US M2 half-track

The M2 didn’t have the rear crew door , and it was about 8 inches shorter in length than the M3 . I would forget about the length issue and use a Rubicon M3 as base for a kit bash . 1st , plate over ( putty / sand ) rear door . 2nd , being that the Rubicon kit gives you the internal seats and over track internal bits ( radios , storage bins , fuel tanks ) , I would cut them up to match the picture I’m using as inspiration . Note some M2s had side doors for ammo bins depending on the weapon towed , so you might have to scribe them on . Note Rubicon’s plastic is much harder than Warlord’s so use a new sharp blade and be careful

Look up M2 Half Track Interior on Google , lots of pictures there . The Rubicon kit gives you the 50 cal on the post mount as well a four 30 cals to mount around the hull sides . If your taking about the I beam skate mount ( 360″ around the interior of the hull ) , you’re going to have to make that yourself , IRC that was an early war design which they deleted in favor of static mounts on the sides ( it partially covered the upper side door frames making it a b*tch to exit the vehicle in a hurry unless you went over the sides ). Squadron/Signal has a good M2/M3 Half Track walk around book with lots of pictures of museum and restored collectors vehicles , should cost under $20 US