Correct measuring

For me, distances are measured from base to base.
I need to double check the rules but it just never occurred to me to wonder about so I may assume too much.

Regarding the arc section, as in most cases the attacking plane ends with a turn before firing, it’s either it can turn enough to go beyond the limit or not. In the second case it will strike from the side which is targeted with less turn.

If the attacking plane use a tight turn or similar ability, I would play it the same as I would consider that it didn’t have enough turn to put itself in the most advantageous position.

Once again, it’s my own interpretation. So take it as a “coherent ruling” try.

• This reply was modified 5 years, 8 months ago by Koin-Koin.

For measuring ranges its base edge to base edge. If using the sabot bases use the original base edge and ignore the sabot itself for measuring ranges.

To determine shooting position draw a straight line between the shooter and target going from base stem to base stem. The facing arc the line passes through determines the shooting position.

In the unlikely event of it being

precisely

along the line you’ll have to roll a dice or flip a coin for it. I can’t honestly ever recall this happening.

My advice is to take a straight edge like a ruler or book spine and line it up above both sides of the plane’s base so its running along the arc lines on the pilot disc and extending them outwards in effect. Things can often look close when you eyeball it but are actually not. I’ve genuinely never had a case that was too close to call when using the ruler method.

Then all I can say is my hat’s off to that level of precision flying, roll a dice for it 🙂