Rigging holes for resin models

This topic has 1 reply, 2 voices, and was last updated 3 years, 9 months ago by Adam Saunders.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
November 19, 2020 at 11:40 pm #183083

Chris
Participant

I’ve been working on my first model, the USS Constitution and got to step 3 of the rigging where you run the lines down from the masts and through the holes in the side. Since this is a resin model, it appears I need to drill the holes. Wanted to see if anyone has suggestions for which tool to use for this. I don’t have any idea and want avoid drilling too big a hole and ruining the model.

thanks in advance!

February 1, 2021 at 9:14 am #183990

Adam Saunders
Participant

I imagine you have your answer by now but for anyone else I’d recommend a hand drill (available at any hobby store or Amazon) using at least a 1.2mm or 1.5mm drill bit and the box art to approximate locations.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.