The above comments are so good there is little I can add, but I would say that when I apply superglue I tend to put a small blob on a surface I don’t care about (say a plate I use for decanting PVA etc.) and dip a cocktail stick in it to then apply the glue. This gives me more control – I find that usual applicators on superglue pots lead to me being messy, and as a result my fingers can end up glued to the piece. There is nothing more frustrating than holding a fiddly little piece in place until the glue sets, but watching the piece you were attaching come away with your finger when you try and release it š It can also help to use a pair of tweezers to hold smaller pieces, as again this can give more control. Hope that helped, and good luck!
