Ramelle scenario

Home Forums Historical Bolt Action D-Day Campaign Ramelle scenario

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #165011
    kevin stronach
    Participant

    Quick couple of questions:
    1) we’re assuming this will be a 3’x3′ table, correct?
    2) no Zones are marked on the map, but assuming Zone 1 is the large “north” area, Zone 2 is the US deployment zone, & Zone 3 is the small strip to tbe “south”?
    3) if the Tiger HAS to use a RUN order then it is meant that it only spends x3 turns on the table?
    – 9″ move x2 for RUN; 18″ move gets it off tbe 36″ table in x3 turns, given that it starts off table so it would need more than 36″ to exit far side

    #165025
    Tom Mecredy
    Participant

    1: You are correct in assuming that it’s a 3×3 table – due to the small forces, Firefight works better on smaller tables.

    2: See attached map.

    3: Replace the movement rules for the tank with the following: If an order dice is issued to the driver, the tank must use an Advance order to move. The tank may not fire any weapons after making this move.

    This should fix it rocketing across the table in 3x turns.

    #167879
    Miguel
    Participant

    Hi, I hope help for these clarifications..

    you say “If an order dice is issued to the driver, the tank must use an Advance order to move. The tank may not fire any weapons after making this move.” …
    1. ok, but if later an order dice is issued to the gunner, he can fire… correct?.
    2. If this correct, when I fire, should I apply -1 for move?

    Thaks!

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.